Installing mast hound

If you are using traditional hook system for attaching your cables to the mast here is an idea of how you can install the “nose” hound type.

Step 1

Prepare the fitting. Fillet the edges and tap two holes. I tap 6mm thread.

Step 2

Prepare the mast to accommodate the fitting. Make sure you get all measurements right. Remember – measure twice – cut once. 

Step 3

Apply glass reinforcement on top of the fitting. I use 6 layers of biax 300g/m2. I use black dye to tint the resin – after excess resin comes out it looks nice from the outside.

Before glass comes on I install two 6mm studs to keep holes opening clear from fibers before putting default screws. 

Step 4

Drive the fitting into the mast. My favorite way is using thin cords (due to limitation in shop space). One cord to pull nose in and the other to take cart out. Notice pull in cord is attached to nose. Once the fitting is in place it will be used tu lift it up.

Step 5

Pull the cart gently inside the tube and lift it up. Have some sort of clamp ready. Once the nose shows up clamp it, remove temporary studs and install screws.

Clean excess resin and leave it overnight.

Step 6

Trim the studs – be careful not to overheat if you do it with angle grinder!

And you are ready to go!

Since some years this system is installed on all Moore Bro. masts. It greatly improves mast rotation and lasts forever. 

In my previous post Mast hound look from inside you can see how the fitting looks from inside.